Introduction:
UF8-R5J is an One-to-Five SATA PM ware RAID/JBOD
enclosure with USB2.0 and FireWire host connection featuring
tray-less and Direct-Air bottom fan
UF8-R5J is designed to provide up to five (5) SATA drives in
various configurations: RAID levels: 0/1/3/5/10/PM/Clone and
JBOB (JBOD is default configuration).
With an easy configuration scheme, our UF8-R5J can function
as JBOB up to five drive a perfect back up device for daily
backup as Mon to Friday using various backup software for
auto scheduling.
UF8-R5J has a self-contained storage processor chip and raid
engine embedded, when used completely frees up the main
CPU loading, make it an ideal for use in external storage
applications
Configurations
Direct mode
1. Configure the storage policy
To configure the storage policy, set the rotary switch to the
desired position. See below figure
a) Push and Hold “
Change Mode Button
” switch
b) Power ON UF8-R5J
c) Release
Change Mode Button
” switch when
enclosure sounds a beep
d) Check with Disk Manager, the new raid volume should
be listed
2. Change the storage configuration
To change the storage configuration, set the rotary switch to
PM (Port Multiplier) position. Keep the “Change Mode Button”
pressed for 3 ~ 5 seconds while power on to delete the old
virtual volume.
Turn off the power and repeat steps in “Configure the storage
policy” section above.
The new raid set will be created.
Utility GUI mode
Download and Install OS GUI utility, currently our GUI support
MAC, Window and Linux
Please refer to:
RAID GUI manual for full usage detail of this utility
You can download manual here:
http://www.datoptic.com/PDF/SPM393_Overview.pdf
For more information, questions or contact, please visit
our forum:
http://www.datoptic.com/Forum/viewtopic.php?f=9&t=205
DAT Optic, Inc.
1815 E. Wilshire Ave., Ste. 906
Santa Ana, CA. 92705
Tel.: 714 558.1808
Fax.: 714.558.3229
www.datoptic.com
