Using the SCM Configuration Menus
5-9
014–002091
NOTE: If you connect a terminal for use as a system console, make sure that the
characteristics settings on the terminal correspond to the parameter settings
for the system console port.
Power down the computer before connecting a new terminal or changing the
terminal characteristics via external switch settings.
If you have a workstation, you
must
disconnect the graphics monitor and
keyboard before powering up using a terminal as system console.
You can use a keyboard control sequence (Ctrl-I) to restore the parameters for the
system console port to the following factory defaults: 9600 baud, 8 data bits, no parity,
ANSI character set, enabled flow control, U.S. English keyboard language. Refer to
Appendix B for adescription of keyboard control sequences.
Changing the System Console Baud Rate
While in the View or Change System Configuration menu, type
and press New Line
to select item 2, Change console parameters." The system displays the Change
Console Parameters menu, with the current baud rate shown in brackets next to
item 1, Change baud rate." Use item 1 to change the baud rate for the system console
port. The default baud rate is 9600 baud.
NOTE: Item 1 applies only if you are using an asynchronous terminal as system
console; this parameter does not apply to a graphics monitor.
Change console parameters
1
Change baud rate [9600]
2
Change character length [8 bit, no parity]
3
Change asynch console mode [ANSI]
4
Change flow control [Enabled]
5
Change console language [US English]
6
Change screen saver timeout [15 minutes]
7
Return to previous screen
Enter choice(s) –>
1
Change baud rate [9600]
Type
and press New Line to select item 1, Change baud rate." The system displays
the Change Baud Rate menu.
Summary of Contents for AViiON 530 Series
