Setup ■ Setting Up Input and Output Media
- 50 -
Data I/O ■ 096-0465-001C
Figure 27:
Tape-Output Module mounting screws (circled). Three
more mounting locations are on back side (hidden in this view).
Ref: The Tape-In mount and chute are in the foreground.
S
ETTING
U
P THE
T
APE
O
UTPUT
M
ODULE
CAUTION: Possible tape damage from excessive heat! Improper routing
of the device tape may cause enough heat to melt the tape. Ensure the
correct routing path is followed. See the TM-50 Tape Output System
User’s Guide.
To set up the Tape Output System:
1.
Edit the winAH400.ini file for Tape Output—
1a.
Using Windows Explorer, locate C:\CH700\winAH400.ini
and make a backup copy, for example,
winAH400backup.ini.
1b.
Open the original file with Microsoft Notepad.
1c.
Locate the line: TapeOutPutInstalled=FALSE and change it
to True: TapeOutputInstalled=TRUE
1d.
Save the winAH400.ini file and exit Windows Explorer.
2.
The Tape Output Module gets power and air from the PSV5000
System. Connect the compressed air, electrical power, and
communication (Just right below the Tape Output System).
3.
Ensure the PSV5000 System air is connected and power is ON.
4.
Switch the Tape Output Module ON by pressing the power switch.
Summary of Contents for PSV5000
