Memory is corrupted or is not initialized.
To initialize memory,
Set the switch to service mode then press and hold the Reset key until P00 is displayed.
Memory error.
Replace the Jukebox Control Unit board (problem with memory chip U4).
Not a valid song request command.
Communication problem between the JCU board and MP3 player board.
Press Reset and see if the error re-appears (could be a power supply problem).
MP3 player timeout.
The MP3 player took too long to start playing.
Press Reset and see if the error re-appears (could be a compact flash card problem).
The requested song was not found.
Check the folder & file number to see if the song exists.
This error does not require a reset operation. If "Coin Operation", credit is added back.
MP3 player did not respond with a command acknowledgment.
Communication problem between the JCU board and MP3 player board.
Press Reset and see if the error re-appears (could be a power supply problem).
Key pad key is stuck on (checked when entering service mode).
To confirm key pad problem,
Unplug connector P4, turn the unit on and see if the error re-appears .
Coin switch is stuck on (checked when entering service mode).
To confirm coin switch problem,
Unplug connector P5, turn the unit on and see if the error re-appears .
Service mode programming has been defaulted to factory settings.
Affirmative response to entering service mode and holding the Reset key for about 8-seconds.
WALLBOX DISPLAY - ERROR CODES
# Of Blinks
Error Type
Corrective Action
1
System Error Make sure the Compact Flash adapter and memory card are inserted correctly
2
Format Error Make sure the Compact Flash memory card is formatted as a FAT32 filesystem
3
No Folders
Make sure you have created folders for your selections
5
CF Error
Got a Compact Flash read error, Try another memory card.
PLAYER STATUS LED - ERROR CODES
4
No MP3 Files Make sure folders are not inside folders and song files are MP3, Not WMA or AAC
1
2
3
4
5
6
7
8
9
*
0
#
P4-8
P4-7
P4-6
P4-4
P4-5
P4-2
P4-3
ALTERNATE KEYPAD OPTION
The Jukebox Control Unit will work with two types of input keypads, the
Seeburg DEC wallbox keypad or a standard matrix keypad.
A standard matrix keypad is made up of rows and columns. Each key
connects one row to one column. If your using the JCU for a custom
jukebox or wallbox, then the matrix keypad option should be used.
To change the keypad option, place the JCU in SERVICE mode (0).
Using the wireless remote ...
Press CHANNEL down for Seeburg DEC keypad scan (displays P40).
Press CHANNEL up for standard matrix keypad scan (displays P41).
JCU Keypad
Connector "P4"
ROW4
ROW1
ROW2
ROW3
COL1
COL2
COL3
