1. Input the DDNS server name in the Dynamic DNS Provider field.
2. Input the Account, Password and DDNS name provided by the DDNS provider.
3. Click the Apply button to save it.
3.7.2 Firmware Upgrade
You can upgrade the firmware including : Root file system (root_ulmage), Boot loading
Code (uboot.img) and Factory EEPROM settings from this submenu.
It is recommended strongly that this is performed by a qualified technician.
1. Upgrade the Root File System (RootFS) :
Click the Browse button to locate the RootFS upgrade code saved on your disk.
Normally the filename is root_u/mage, then click the Apply button. After writing the
code into the flash menu, the system will reboot automatically. It will take about
2 minutes to complete.
2. Upgrade the Bootloader code (Uboot) :
Click the Browse button to locate the Uboot upgrade code saved on your disk.
Normally the filename is uboot.img, then click the Apply button . After writing the
code into the flash menu, the system will reboot automatically. It will take about
1 minute to complete.
3. Upgrade the Factory EEPROM settings:
This function is only used for changing the factory MAC address of this device.
Click the Browse button to locate the EEPROM data file saved on your disk.
Normally the filename is RT305xeeprom.bin, then click the Apply button.
After the system finishes this operation, the RESET button on the device needs
to be pressed for the new MAC address to be set in memory.
3.7.3 Settings Management
Through this function you backup system settings by exporting them to a
configuration file, restore them by importing the file, or reset them to the factory default.
Click Administration, then Settings Management in the main menu and enter the page as
Shown in figure 29.
