5
MP-1000 Unit initial Setup
MP-1000 Installation
A High speed CF (Compact Flash) memory card is required to use this product.
A Scandisk Ultra II 2GB card is already fitted internally but larger capacity cards upto 16GB can be used.
If not already done format the CF card to
FAT32
using a PC this will ensure better performance.
Remove or Fit the CF card into the MP-1000 using the CF card slot on the left hand side of the unit.
Connect the MP-1000 via Ethernet LAN cable to your PC, Local Area Network or Internet router.
Connect video and audio cables between the MP-1000 and your monitor or connect the VGA output to a
compatible PC monitor (
see Warnings and Precautions page
).
Power on the MP-1000 unit.
MP-1000 Start up sequence
1. When the unit is first set up with a monitor, speakers and is powered on it will go through the
following sequence.
2. It will display a picture to the monitor saying
Network Digital Signage Player
.
3. It will then send an audible
PING
sound to the attached audio speakers.
4.
If there is a configuration file on the CF card then the unit will display
AUTO UPDATING…
5. It will then look for a network connection through the RJ-45 port and display
INTIALIZING LAN
…
6. NB: “Connecting to DHCP Server” may take longer depending on the speed of the
network router in assigning an IP address to the MP-1000(s).
7. If the unit finds no network then it will check its internally fitted Compact Flash (CF) card for
media, miaticker and playlist files.
8. If the CF card in the unit is blank then the unit will display the initial MP-1000 Setting Menu as
below and then wait for user intervention.
MP-1000 SETTING MENU [ V 2.9.87.0106U ]
Device Local IP : 192.168.1.11
Server IP : 192.168.1.10
User : NDSP01
Time : YYYY/MM/DD HH:MM
MAC : XX - XX - XX - XX - XX – XX
Server Connection : OFF
Storage : 1952 MB
SETUP
STORAGE
Note :
[ V 2.9.87.0106U ] = firmware revision