10 / 11
Supported IR Data Format
1. Connect your HDMI or DVI source (such as a Blu-ray Disc player) to the transmitting
unit ET-HD0101-TC.
2. Connect the IR blaster to the transmitting unit ET-HD0101-TC, and make the IR
blaster directly point to the IR sensor of the HDMI source device.
3. Connect your HDMI or DVI display (such as a LCD or plasma HDTV) to the receiving
unit ET-HD0101-TC.
4. Connect the IR receiver to the receiving unit ET-HD0101-TC, and make the IR receiver
directly point to the user.
5. Connect two Cat-5/5e/6 cables between the transmitting and receiving units via A/V
SIGNAL and CTRL CHANNEL ports respectively.
6. Make sure your LAN cables are tightly connected and not loose.
7. Plug in 5V DC power cord to the power jack of the receiving unit ET-HD0101-TC.
8. If you see flickering or blinking image on the display, try to adjust the rotary
control switch to improve the cable skew. 0 stands for the strongest HDMI signal
level for longest possible transmission length while 7 stands for the weakest
HDMI signal level for short transmission length. Try adjusting the signal level
from 7 to 0 to find the optimal setting for the HDMI over CAT5 transmission.
