7 / 10
2. For desirable 1080p video output, please follow the instructions below:
Step 1 – Please set the rotary arrow on TX at “
Mode 6
” for Default Mode, and
wait for the LED of the RJ-45 connector blinks for a couple seconds.
Step 2 – Please turn the rotary arrow clockwise
[
]
from
Mode 6
to
Mode 1
. If
you can get audio/video from the display, you can stay tune at this
setting for 1080p and stereo audio. If you need to get 1080p with 7.1ch
audio output, please turn the rotary arrow counterclockwise
[ ]
from
Mode 1
to
Mode 0
. If you cannot get the audio/video out normally,
please go on the next step.
Step 3 – Please turn the rotary arrow counterclockwise
[ ]
from
Mode 0/1
to
Mode 7
. Wait a few seconds until the LED of the RJ-45 connector
dims and then lights again.
Step 4 – Please turn the rotary arrow clockwise
[
]
from
Mode 7
to
Mode 0/1
.
You should have your desirable audio/video output. If not, please
follow the instruction in Note#1.
3. To learn EDID from the HDMI display, please follow the instruction below:
Step 1 – Please connect the display which you want to read EDID with a HDMI
cable to the transmitter’s HDMI IN and set the rotary arrow at
Mode 7
so the TX can learn the EDID information from the connected display.
The LED on the RJ45 connector of TX will dim and light again in a few
seconds, which indicates the EDID learning procedure is complete.
Step 2 – Please turn the rotary arrow clockwise
[
]
from
Mode 7
to
Mode 0
or
Mode 1
for desirable audio setting and enjoy the experience. DO NOT
let the rotary arrow pass by
Mode 5
and
Mode 6
which will erase the
EDID just learned and restore the default EDID.
ET-HK0101-TC Rear View
+5V DC:
Connect to 5V DC power supply.
HDMI Signal OUT:
Plug in a CAT-5/5e/6 LAN cable that needs to be linked to the RJ-45 connector of the
receiving unit ET-HK0101-TC.
