background image

8

compliance could void the user's authority to operate the equipment. 

§ 15.105 Information to the user.

Note: This equipment has been tested and found to comply with the limits for a Class 

B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to 

provide reasonable protection against harmful interference in a residential installation. 

This  equipment  generates  uses  and  can  radiate  radio  frequency  energy  and,  if  not 

installed and used in accordance with the instructions, may cause harmful interference 

to  radio  communications.  However,  there  is  no  guarantee  that  interference  will  not 

occur in a particular installation. If this equipment does cause harmful interference to 

radio or television reception, which can be determined by turning the equipment off 

and on, the user is encouraged to try to correct the interference by one or more of the 

following measures: 

-Reorient or relocate the receiving antenna. 

-Increase the separation between the equipment and receiver. 

-Connect  the  equipment  into  an  outlet  on  a  circuit  different  from  that  to  which  the 

receiver is connected. 

-Consult the dealer or an experienced radio/TV technician for help. 

This equipment complies with FCC radiation exposure limits set forth for an 

uncontrolled environment. This equipment should be installed and operated withmini

mum distance 20cm between the radiator & your body. 

ISED RSS Warning:

 

This device complies with Innovation, Science and Economic Development Canada 

licence-exempt RSS standard(s). Operation is subject to the following two 

conditions: (1) this device may not cause interference, and (2) this device must 

accept any interference, including interference that may cause undesired operation of 

the device. 

Le présent appareil est conforme aux CNR d'ISED applicables aux appareils radio 

exempts de licence.   L'exploitation est autorisée aux deux conditions suivantes:   

(1) l'appareil ne doit pas produire de brouillage, et   

(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même 

si le brouillage est susceptible d'en compromettre le fonctionnement. 

§ 15.21 Information to user.

Any  Changes  or  modifications  not  expressly  approved  by  the  party  responsible  for 

ISED RF exposure statement: 

This equipment complies with ISED radiation exposure limits set forth for an 
uncontrolled environment. This equipment should be installed and operated with 
minimum distance 20cm between the radiator& your body.This transmitter must not 
be co-located or operating in conjunction with any other antenna or transmitter.
Le  rayonnement  de  la  classe  b  repecte  ISED  fixaient  un  environnement  non 
contrôlés.Installation et mise en œuvre de ce matériel devrait avec échangeur distance 
minimale entre 20 cm ton corps.Lanceurs ou ne peuvent pas coexister cette antenne ou 
capteurs avec d’autres.

Summary of Contents for Bolt 4GV









Reviews: