CR805 Retransfer Card Printer User’s Guide
31
Load and Replace Supplies
To keep the printer ready to print cards, load blank card stock into the input hopper, load ink
ribbon and retransfer film on the appropriate cartridges, and load a cleaning sleeve into the
printer.
Load Cards
Do the following to load cards in the input hopper. If you plan to insert cards manually using the
exception slot, keep a supply of blank cards available.
Cards can stick together. Slide or fan the cards to separate the edges before placing them in
the input hopper. Handle cards by their edges only, or wear gloves.
Insert ISO magnetic stripe cards with the stripe (back side) facing down and to the right.
Insert smart cards with the smart card chip facing up and toward the back of the hopper.
Single Hopper Printer
1.
Unlock the input hopper lock, if necessary, and open
the input hopper door.
2.
Load the cards into the input hopper. The hopper can
hold up to 125 cards.
3.
Close and lock the input hopper, if necessary.
If your system includes the optional laminator, also load overlay material into the L1
and L2 (if equipped) laminators. Refer to
“Load Laminator Overlay Material”
, for information about loading the laminator cartridges.
A diagram inside the input hopper shows the correct orientation for each type of card.
Summary of Contents for CR805
