94
Error Recovery and Messages
Changing the Left-to-Right Position
Use
the
Status
Monitor
to
change
the
left
‐
to
‐
right
position
of
the
patch
on
the
card.
Refer
to
“Laminator
Tab”
on
page 47
to
use
the
Film
Position
setting.
Use
the
following
steps
to
change
the
left
‐
to
‐
right
patch
position:
1.
Open
the
Status
Monitor
on
the
PC
and
select
the
Laminator
tab.
2.
Move
the
slider
in
the
Position
box
to
adjust
the
patch
position
left
or
right
for
either
the
top
‐
side
or
bottom
‐
side
film
cartridge:
Moving
the
slider
to
the
left
moves
the
patch
to
the
left
side
of
the
card.
Moving
the
slider
to
the
right
moves
the
patch
to
the
right
side
of
the
card.
3.
Click
Update
to
update
the
laminator
settings.
4.
Laminate
a
card
to
verify
the
new
patch
position.
Correcting Card Warping
When
laminated
cards
warp,
the
optional
printer
bend
remedy
can
correct
the
problem.
Refer
to
“Bend
Remedy
Tab”
on
page 44
.
If
a
bend
remedy
option
is
not
present,
lower
the
laminating
temperature
or
increase
the
laminating
speed
to
help
reduce
card
warping.
Refer
to
“Laminator
Tab”
on
page 47
to
change
these
settings
using
the
Status
Monitor.
