27
© 2010 Datacom Systems Inc
Initial Configuration
DURA
stream
™
5.2 SERIAL Port Configuration (RJ45)
Note
: Use the Console Cable (DB9 to RJ45) through the
CONSOLE
RJ45 port for initial configuration of
the hardware. Once DS-1010 series connection is made, open the terminal emulation application and create
a connection with settings that fit your needs as described in the '
HyperTerminal
' section.
5.2.1 HyperTerminal
Any freely available terminal emulator may be utilized, but please take note of the specific Microsoft
HyperTerminal settings in the following example, if an alternate terminal emulator is used.
HyperTerminal (terminal emulator) enter:
115,200 bits per second; 8 data bits; Parity none; 1 stop bit; Flow control none
After completing review of the
Command Line Interface (CLI)
section, detailed IP Address
configuration can be found in the
IP Address Configuration
section.
5.2.2 IP Address Configuration
All DS-1010 series units are shipped with a
factory default
configuration as follows:
IP Address:192.168.0.111; Subnet Mask: 255.255.255.0; default Gateway: 192.168.0.1
IMPORTANT:
If you expect to remotely connect to the DS-1010 series, you must change the IP Address,
Subnet Mask and default Gateway to match your Local Area Network.
The IP address can be configured via a serial connection with either Microsoft's
HyperTerminal
application
(available on most Windows PCs) or an open source free software terminal emulator for MS-Windows.
Step 1.
Using a supplied AC switching adapter and line cord, plug the DS-1010 into an AC power source.
Step 2.
Connect your PC and DS-1010 using the provided Datacom Systems
CONSOLE
cable. Create a
HyperTerminal (terminal emulator)
COM
port (115,200, 8, None, 1, None) serial link.
Step 3.
You are now connected to your DS-1010 series. All Usernames and passwords are case-sensitive.
datacom login: admin
(default value)
<enter>
Password: admin
(default value)
<enter>
Step 4.
Set IP, MASK and GATEWAY at the ~ $
prompt as follows:
cli set ip xxx.xxx.xxx.xxx
<enter>
cli set mask xxx.xxx.xxx.xxx
<enter>
cli set gw xxx.xxx.xxx.xxx
<enter>
Step 5.
Close HyperTerminal and disconnect the
CONSOLE
serial cable.
Step 6.
Install the DS-1010 series in your chosen network location.
27
22
27