DM-
SV01 ● Product Manual ● Rev. 1.1
50
4.2.1 BMC management Interfaces
There are two interfaces that can be used to access the BMC, including the web interface.
1. Using the frontal RJ45 connector for out of band management. This port is connected directly
to BMC. The RJ45 connector is located at the front panel of the motherboard, as shown below.
Figure 53: LAN Connector
2. Through the Mezzanine Card, using the NC-SI interface. The NC-
SI or “network controller
sideband int
erface”, is an electrical interface and protocol that allows the BMC to share the
network connection of the NIC port for management traffic purposes, in addition to the regular
host traffic. When the NIC has two ports available, The NC-SI interface is available at the port
on the right side of the Mezzanine card (Mezzanine port 0).
Figure 54: NC-SI mezzanine port