DM-
SV01 ● Product Manual ● Rev. 1.1
68
The procedure for removing the cage E1.S from the slot is described below.
1. Completely remove power from the system (remove the DM-SV01 server from the shelf).
2. Unscrew the fixing screw.
3. Hold the cage E1.S and pull it up vertically until it is completely removed from the connector.
5.6 E1.S disks installation
The DM-SV01 is compatible with 5.9mm or 9.5mm thickness E1.S disks, as explained in section
2.2.12.1. The E1.S disks are fully hotplug compatible, so they can be inserted in or removed from the
system whenever necessary, even if the server is powered and the OS is running.
The procedure for inserting or removing the E1.S disk is very simple and it is described hereafter. The
procedure is the same for inserting an E1.S disk into both the Cage E1.S and the 2xE1.S PCIe adapter
card.
For inserting an E1.S disk in the server, please refer to the procedure below.
1. Position the E1.S disk in the slot you would like to insert it.
2. Slide it all the way to the end and then push it slightly until you notice that the connection has
been established.
For removing an E1.S disk in the server, please refer to the procedures below.
For disks connected to the E1.S cage Type I or to the 2xE1.S adapter card Type I:
1. Press the blue pin to the left side and hold it while pulling the disk away from the connector, in
order to disconnect it from the mechanics.
Figure 80: removing the E1.S disk from 2xE1.S adapter Type I
2. Slide the disk off the slot until it is completely removed.
For disks connected to the E1.S cage Type II or to the 2xE1.S adapter card Type II:
1. Press the blue pin down and hold it while pulling the disk away from the connector, in order to
disconnect it from the mechanics.