Manual Datafox ZK-MasterIV
3.9 Status message of the access control
For the admission control following state messages are defined. The decimal values of the state message
can be saved to every data record.
Display
Assigned status message
0
Module recognised, everything is okay
3
Module not defined in the list but found in the bus
4
Module from the list not found in the bus
5
Module wrong coding password
6
Module wrong login password
7
Module wrong reader type (Mifare, Legic, Unique, etc.)
8
Module error while configuring the module
9
Module neither found in the list nor in the bus (is not used)
10
The communication key for the PHG-Crypt-protocol has been changed
11
The communication key for the PHG-Crypt-protocol has not been
changed
Table 17: Initialization / Communication
Display
Assigned status message
20
Access granted for this card number
21
Card number not contained in the identification list
22
Card number blocked
23
Time of validity of card number expired
24
Room not contained in the location list
25
No access during this time
26
Awaiting PIN entry (green LED flashes)
27
Entered PIN is invalid
28
PIN with menace code was entered
29
Entered PIN is OK
30
Entered master PIN is OK
31
Time-out for PIN entry
32
Card number with general authorization
34
Card number in the online mode read
35
PIN in the online mode read
100
Access control deactivated in the setup
101
At the moment the access control cannot be called up (busy)
102
Access control needs the lists
103
Incorrect bus type (Datafox, PHG, etc.)
Table 18: Access control
Version: 04.01.07.00
Page
91
www.datafox.de
