8
WWW.RAPIDRH.COM
WAGNER METERS
DataGrabber with Bluetooth
A pop-up window will appear on the RH Reading screen if
detecting an installed DataGrabber with Bluetooth device
for the first time. In addition, if you are in proximity of any
DataGrabber with Bluetooth units installed in L6 sensors, on
the Devices screen the unit with the greatest signal strength will
appear as the first unit at the top, followed by other DataGrabber
units within Bluetooth range. You can begin to configure your
DataGrabber units (see the Configuration section).
DataGrabber (without Bluetooth)
Use the Total Reader with the DataGrabber to connect to the
DataMaster L6 app on your mobile device. A pop-up window
will appear on the RH Reading screen if detecting an installed
DataGrabber device for the first time. IMPORTANT: You must
connect the Total Reader with the DataGrabber TWICE for it to
start working. The first time initializes the DataGrabber device,
and the second time verifies that the device is taking readings. If
you transfer the DataGrabber to a new L6 Smart Sensor, you will
need to repeat this process.
Whenever the Total Reader is properly connected to the
DataGrabber, it will appear on the app’s Devices screen, as
named, along with any DataGrabber with Bluetooth devices.
You can now select your DataGrabber device and configure its
settings as needed.
NOTE
: On the Devices screen, you can easily identify the type
of device that is connected to your L6 sensor by the icon to the
left of the Device name:
DataGrabber with Bluetooth
DataGrabber
Total Reader
D
TR
DB
