DKM-40
7 Kullanım Kılavuzu V-1.1
2
Electrical equipment should be installed only by qualified
specialist. No responsibility is assured by the
manufacturer or any of its subsidiaries for any
consequences resulting from the non-compliance to
these instructions.
Check the unit for cracks and damages due to
transportation. Do not install damaged equipment.
Do not open the unit. There is no serviceable parts inside.
Fuses must be connected to phase voltage inputs, in
close proximity of the unit.
Fuses must be of fast type (FF) with a maximum rating of
6A.
Disconnect all power before working on equipment.
When the unit is connected to the network do not touch
terminals.
Short circuit terminals of unused current transformers.
Any electrical parameter applied to the device must be in
the range specified in the user manual.
Do not try to clean the device with solvent or the like.
Only clean with a dry cloth.
Verify correct terminal connections before applying
power.
Current Transformers must be used for current
measurement.
No direct connection allowed.
SAFETY NOTICE
Failure to follow below instructions will
result in death or serious injury