DKM-40
7 Kullanım Kılavuzu V-1.1
26
The device firmware version is displayed as
shown in the lefthand figure.
P2.7 indicates that the firmware version is
2.7.
The firmware version will be required by the
manufacturer together with any technical
support request.
The unit is factory calibrated before
shipment.
If recalibration is required, Please enter
“3282” at the bottom display then press
button.
The calibration screen for L1 phase voltage
will appear. 1 second after, the coefficient
used for measuring the voltage will appear
in displays 2 and 3.
Pressing
buttons will
increase/decrease the measured value.
When the measured value is correct press
button. The next input will come to
display.
Repeat above procedure for each input to
be recalibrated.
4.21 CALIBRATION
4.20 DISPLAYING THE FIRMWARE VERSION