DL4 FE Encrypted External Hard Drive - v1.49/6.5.0 - User Guide
At A Glance
Introduction
Congratulations on your purchase of the DataLocker DL4 FE (FIPS Edition) hardware encrypted
external hard drive.
Although the DL4 designed with user friendliness at its core, it is recommended that you review this
guide to ensure that you become fully acquainted with your DL4 and make the most of all of its
features.
General operation of the encryption
Your DL4 utilizes a hardware encryption engine to encrypt and decrypt data that you store on the
device. When your device is plugged in and powered on, you will authenticate with the onboard
system using your password to enable the encryption and use your data. When you lock, power
off or disconnect your device, the data is stored in an encrypted state.
Updating Your Device
Updated software and documentation are freely available for download at our website:
• Latest device updates -
http://datalocker.com/device-updates
• Documentation and support -
https://support.datalocker.com
Important:
Only the latest device updates should be applied to the device. Downgrading the
device to an older software or firmware version is not supported and can potentially cause a
loss of stored data or impair other device functionality. The latest device updates will always be
available at the link above.
About the DL4
The DL4 FE is a FIPS 140-2 Level 3 and Common Criteria cPP certified device
built around a pow-
erful AES 256-bit cryptographic hardware architecture that then adds layer after layer of security
with automated policies that intelligently change its security posture based on its location, how
it’s being used, and the type of data being stored on it. Available as a SSD or a more eco-
nomical HDD, the DL4 FE meets the strictest security requirements while offering large-capacity
storage (up to 15.3 TB) and an easy-to-use touchscreen for setup and use. A powerful addition
to the DataLocker line of securely managed solutions, the DL4 FE continues our proud tradition of
providing Simply Secure™ solutions, plus it’s backed by a limited 3-year warranty. The DL4 is fully
cross-platform compatible and OS agnostic. With no software or special drivers required, works
with Windows, Linux, and macOS.
1
The DL4 FE has been designed for FIPS 140-2 Level 3 and is being tested by an accredited NIST lab. The product is in
process for certification and is officially listed by NIST. DL4 FE is also in process to achieve Common Criteria cPP certification.
The official listing as a Product under Evaluation by NIAP is expected in March 2021.
© 2021 DataLocker Inc. All rights reserved.
4
