Sentry K300 SafeConsole Deployment guide
Disabled Menu Options
When SafeConsole mode is enabled, the following menu entries on the K300 are disabled:
• BOOT MODE - Not compatible with SafeConsole
• USER PASSWORD - Previous user passwords are disabled and not compatible with SafeConsole
• SAFECONSOLE - Cannot be disabled once locked. Contact
with
questions
• READ ONLY MODE - Not available within the main menu. Still available in the connection
menu
• ZEROIZE - Admins should use the SafeConsole Factory Reset device action instead
SafeConsole Registration
Once SafeConsole is enabled on the Sentry K300, the device will need to be registered to a
SafeConsole server. This is accomplished by launching a Windows client that is loaded on the K300
when SafeConsole is enabled using the steps above. This Windows client will be mounted to a
separate CD ROM partition. SafeConsole registration can either be done by the End User or by an
Admin.
End User Registration To SafeConsole (Recommended)
1. A SafeConsole Administrator should send out the SafeConsole Endpoint Setup Guide to the
user by entering the user’s email address in the SafeConsole Deployment Wizard found in the
Help section of SafeConsole, under
Deployment Wizard
.
2. The End User will need to unlock the K300 using the admin password and select
CONNECT
from the Connection Menu before plugging their device into their Windows workstation.
3. The CD ROM partition that contains the Unlocker application will then be mounted to the
workstation. Follow the Endpoint Setup Guide to launch the Unlocker Client and enter the
information needed for registration.
4. The Unlocker client will ask the user to enter the K300 password. Enter the K300’s Admin
password. All letters should be entered as capitals.
5. If a valid filesystem (FAT32, exFAT, NTFS) is not found on the K300, such as when registering
after receiving a factory reset through SafeConsole, then the Unlocker client will attempt to
format the K300 with the user selected filesystem. This action may prompt for Window’s admin
permission through a UAC, User Account Control, prompt.
6. Registration is complete once the Control Panel is shown.
© 2018 DataLocker Inc. All rights reserved.
5
