C-BOX 300/310
18
2
2.8.1 GET/TEST/SEND
Functions
The C-BOX 300 has three internal function buttons. In the C-BOX 310, these three
buttons are available on the cover, under the display.
C-BOX 300
GET
TEST
SEND
C-BOX 310
The procedure to enable the GET/TEST/SEND function is the following:
1. Press both the buttons left and right at the same time for at least one second;
the warning LED is turned ON.
2. Release the buttons.
3. Press the left button corresponding to the GET function, the center button
corresponding to the TEST function
or
the right button corresponding to the
SEND function.
GET
–
(left button): the C-BOX 3X0 reads the current scanner configuration and
permanently copies it in its own memory support (EEPROM). The C-BOX
3X0 preserves this configuration also when switched off.
TEST
-
(center button): the C-BOX 3X0 forces the scanner to run the Test
Operating Mode (refer to the scanner Installation Manual for details).
