Datalogic DIAMOND D531, Quick Reference

DIAMOND™ D531 

COMPLIANCE 

FCC COMPLIANCE 

Modifications or changes to this equipment without the expressed written 
approval of Datalogic could void the authority to use the equipment. 

This device complies with PART 15 of the FCC Rules. Operation is subject to 
the following two conditions: (1) This device may not cause harmful 
interference, and (2) this device must accept any interference received, 
including interference which may cause undesired operation. 

This equipment has been tested and found to comply with the limits for a Class 
B digital device, pursuant to part 15 of the FCC Rules. These limits are 
designed to provide reasonable protection against harmful interference in a 
residential installation. This equipment generates, uses and can radiate radio 
frequency energy and, if not installed and used in accordance with the 
instructions, may cause harmful interference to radio communications. 
However, there is no guarantee that interference will not occur in a particular 
installation. If this equipment does cause harmful interference to radio or 
television reception, which can be determined by turning the equipment off and 
on, the user is encouraged to try to correct the interference by one or more of 
the following measures: 
-  Reorient or relocate the receiving antenna. 
-  Increase the separation between the equipment and receiver. 
-  Connect the equipment into an outlet on a circuit different from that to which 

the receiver is connected. 

-  Consult the dealer or an experienced radio/TV technician for help. 

POWER SUPPLY 

This device is intended to be connected to a UL Listed/CSA Certified computer 
which supplies power directly to the reader or else be supplied by a UL 
Listed/CSA Certified Power Unit marked “Class 2” or LPS power source rated  
5 V, minimum 390mA, which supplies power directly to the reader via the power 
connector of the cable. 

WEEE COMPLIANCE 

23