Datalogic DS1500-1100, Quick Manual

DS1500 QUICK GUIDE

2  

Power Supply: 

-  This product is intended to be installed by Qualified Personnel only. 

- All 

Models: 

This accessory device is intended to be supplied by a UL Listed or CSA Certified Power Unit with «Class 2» or 
LPS power source, which supplies power directly to the scanner via the 

15

-pin connector. 

 
The scanner is classified as a Class 2 laser product according to EN 60825-1 regulations and as a Class II laser 
product according to CDRH regulations. 
 
Disconnect the power supply when opening the device during maintenance or installation to avoid exposure to 
hazardous laser light. 
 
There is a safety device, which allows the laser to be switched on only if the motor is rotating above the threshold 
for its correct scanning speed. 
 
The laser beam can be switched off through a software command (see also the WinHost Help On Line). 
 

Warning and Device Class Label 

 
The laser diode used in this device is classified as a class 3B laser product according to EN 60825-1 regulations 
and as a Class IIIb laser product according to CDRH regulations. As it is not possible to apply a classification 
label on the laser diode used in this device, the following label is reproduced below. 
 

LASER LIGHT 

AVOID EXPOSURE TO BEAM 
CLASS 3B LASER PRODUCT 

MAX. OUTPUT RADIATION  35 mW 

EMITTED WAVE LENGTH  630~680 nm 

TO EN 60825-1 (2001) 

Laser Diode Class Label 

 
Any violation of the optic parts in particular can cause radiation up to the maximum level of the laser diode (35 
mW at 630 to 680 nm).