DS5100 REFERENCE MANUAL
24
2
2.3.2 X-PRESS Functions
Quick access to the following functions is provided by
an easy procedure using the push button:
1
–
Press
the button (the STATUS LED will give a
visual feedback).
2
–
Hold
the button until the specific function LED is
on (TEST, LEARN or SETUP).
3
–
Release
the button to enter the specific function.
Once button is pressed, the cycle of LEDs activation is as follows:
Release button to
Exit
Release button to
enter Test Mode
Release button to
enter AutoLearn
Release button to
enter AutoSetup
Release button to
enter Focus Lock/Unlock
(cycle)
Release button to
Exit
Test Mode Function
Once entered, the Bar-Graph on the five LEDs is activated and if the scanner starts reading
barcodes the Bar-Graph shows the Good Read Rate. In case of no read condition, only the
STATUS LED is on and blinks.
To exit the Test Mode, press the X-PRESS push button once.
Summary of Contents for DS5100
