DS6300 DEVICENET
19
The details of the connector pins are indicated in the following table:
26-pin D-Sub Connector Pinout
Pin Name
Function
1
Shield
Internally connected by capacitor to chassis
20
RXAUX
Receive data of auxiliary RS232 (referred to GND)
21
TXAUX
Transmit data of auxiliary RS232 (referred to GND)
8
OUT 1+
Configurable digital output 1 – positive pin
22 OUT
1- Configurable
digital output 1 – negative pin
11 OUT
2+ Configurable
digital output 2 – positive pin
12 OUT
2- Configurable
digital output 2 – negative pin
16 OUT
3A Configurable
digital
output 3 – polarity insensitive
17 OUT
3B Configurable
digital
output 3 – polarity insensitive
18 EXT_TRIG
A External
trigger (polarity insensitive)
19 EXT_TRIG
B External
trigger (polarity insensitive)
6
IN2A
Input signal 2 (polarity insensitive)
10
IN2B
Input signal 2 (polarity insensitive)
14
IN3A
Input signal 3 (polarity insensitive)
15
IN4A
Input signal 4 (polarity insensitive)
24
IN_REF
Common reference of IN3 and IN4 (polarity insensitive)
9, 13
VS
Supply voltage – positive pin
23, 25, 26 GND
Supply voltage – negative pin
10
19
1
18
9
26
26-pin male D-sub Connector
Pin
RS232
RS485 Full-Duplex
RS485 Half-Duplex
20 mA C.L
(INT-30 with C-BOX 100 only)
2 TX
TX485+
3 RX
RX485+
4 RTS
TX485- RTX485-
5 CTS
RX485-
7 GND_ISO GND_ISO GND_ISO
see INT-30 instructions
*
For 20 mA C.L. connections, GND is the same of the scanner power supply.
9-pin Lonworks Connector Pinout
Pin Name
Function
1 Shield
Cable
shield
9
VS
Supply voltage – positive pin
2
GND
Supply voltage – negative pin
6
VS_I/O
Supply voltage of I/O circuit
3 Ref_I/O
Reference voltage of I/O circuit
4 SYS_ENC_I/O
System
signal
5 SYS_I/O
System
signal
7
LON A
Lonworks line (polarity insensitive)
8
LON B
Lonworks line (polarity insensitive)
5
1
9
6
9-pin female Local Lonworks Connector
5-pin DeviceNet Connector Pinout
Pin Name
Function
2
V+
Supply voltage – positive pin
5
CAN_L
CAN bus data line – L
1 SHIELD
Shield
4
CAN_H
CAN bus data line – H
3
V-
Supply voltage – negative pin
1
3
2
4
5
5-pin male DeviceNet Connector
NOTE
The power supplied on pin V+ and V- is used only to propagate power to the section of the
DeviceNet board directly connected to the Bus. It is completely isolated from the DS6300 power
which must be supplied on pin 9, 13 and pin 23, 25 of the 26-pin Main/Aux connector.
