DS6400 REFERENCE MANUAL
86
9
9.2 ADVANCED CODE RECONS
TRUCTION (ACR™ 4)
The traditional way of barcode reading could be called “Linear Reading”. In this case, the
laser beam crosses the barcode symbol from its beginning to its end as shown in the
following figure:
Laser Beam
Figure 101
– Linear Reading
In Advanced Code Reconstruction mode it is no longer necessary for the laser beam to cross
the label from the start to the end. With just a set of partial scans on the label (obtained using
the motion of the label itself), the DS6400 is able to “reconstruct” the barcode. A typical set of
partial scans is shown in the figure below:
Code Direction
Figure 102
– Partial Scans
None of the partial scans contains the whole label. The decoder aligns each partial scan
correctly and combines them in order to obtain the entire code.
This alignment is performed by calculating the time difference from one partial scan to
another using a reference code element.
9.2.1 Tilt Angle for Advanced Code Reconstruction
The most important parameter in Advanced Code Reconstruction is the value of the
maximum tilt angle ( maximum) under which the code reconstruction process is still
possible.
Laser Beam
= tilt angle
0° to
max
Figure 103
– Tilt Angle
Summary of Contents for DS6400
Page 1: ...DS6400 Reference Manual ...
Page 159: ...www datalogic com ...
