USING GRYPHON™ D432/D432E
2
normal operation. To capture another image you must read another Capture Image
Code of the same or a different Preset Configuration.
You can use the aiming system to position the reader from the object (ensure the
reader is about centered over the target). Adjust the distance at which you are
holding the reader (see Figure 2).
If the RS232 interface has been selected, the image will be transferred to the host
PC via XMODEM_1K protocol.
Image capturing is not available in Wedge and USB Keyboard
Emulation interfaces and is not compatible with Autoscanning nor
when the Software trigger type is selected.
NOTE
Up to four different and independent Image Presets can be defined (see page 74).
For each Image Preset you may set up to three Basic Configuration Parameters, and
p to five Advanced Configuration Parameters. Therefore an image is
u
processed
efore being sent to the Host, according to a preset group of parameters.
The lower resolution setting yields smaller file
fine the Image Quality level to address tradeoff
etween image file size and quality.
b
2.3.1
Basic Configuration Parameters
The Image file formats supported are: BMP, TIFF
,
JPEG (default).
Two resolution options are available: VGA Resolution (640 x 480 pixels) (default),
nd CIF Resolution (320 x 240 pixels).
a
sizes, so the transfer time decreases.
or JPEG images it is possible to de
F
b
5
Summary of Contents for Gryphon D432E
