Linking the Reader
16
GRYPHON™ I GBT/GM4500
LINKING THE READER
Link Datalogic Devices to Base
Before configuring the interface, it is necessary to link the
handheld with the base.
To link the handheld and the base, simply put it into the
base. If the reader was previously linked to another base,
you must first scan the
Unlink
bar code before re-linking it
to the new base.
Unlink
Link Scanner as Serial Device to a Bluetooth Host
Use this procedure to let the scanner communicate with a
Bluetooth host using the Bluetooth Serial Port Profile
(SPP).
1. If using a Bluetooth adapter on the host device, install
any driver provided with the adapter.
2. Scan the
Link to Host in SPP mode
label below to
make the scanner visible to the host device.
3. Use the Bluetooth manager of the host device to “Dis-
cover new devices” and select "GBT4500...".
If you receive an error message, it may be necessary
to change the security settings on either the host
device or the scanner.
4. Use an RS-232 terminal program to see incoming data
on the port designated by the Bluetooth manager of
the host device.
Link to Host in SPP Mode
Summary of Contents for Gryphon I GBT4500
Page 59: ......
