LED and Beeper Indications
Quick Reference Guide
35
LED and Beeper Indications
The reader’s beeper sounds and its LED illuminates to indicate
various functions or errors on the reader. An optional “Green
Spot” also performs useful functions. The following tables list
these indications. One exception to the behaviors listed in the ta-
bles is that the reader’s functions are programmable, and may or
may not be turned on. For example, certain indications such as
the power-up beep can be disabled using programming barcode
labels.
INDICATION
DESCRIPTION
LED
BEEPER
Power-up Beep
The reader is in
the process of
powering-up.
Reader beeps
four times at
highest fre-
quency and vol-
ume upon
power-up.
Good Read Beep
A label has been
successfully
scanned by the
reader.
LED behavior
for this indica-
tion is configu-
rable via the
feature “Good
Read: When to
Indicate”
(see the PRG for
information.)
The reader will
beep once at cur-
rent frequency,
volume, mono/
bi-tonal setting
and duration
upon a success-
ful label scan.
ROM Failure
There is an error
in the reader's
software/pro-
gramming
Flashes
Reader sounds
one error beep at
highest volume.
Limited Scan-
ning Label Read
Indicates that a
host connection
is not established
when the IBM or
USB interface is
enabled.
N/A
Reader 'chirps'
six times at the
highest fre-
quency and cur-
rent volume.
Reader Active
Mode
The reader is
active and ready
to scan.
The LED is lit
steadily
a
N/A
Summary of Contents for Gryphon I GM4100-BK
Page 4: ...NOTES...
Page 54: ...Regulatory Information 50 Gryphon I GM410X NOTES...
