Select the Interface Type
Quick Reference Guide
15
Select the Interface Type
Upon completing the physical connection between the
reader and its host, proceed directly to
for information and programming for the
interface type the reader is connected to (for example: RS-
232, Keyboard Wedge, USB, etc.) and scan the appropriate
barcode to select your system’s correct interface type.
Interface Selection
Each reader model will support one of the following sets
of host interfaces:
General Purpose Models —
RS-232, RS-232 OPOS, USB, Key-
board Wedge
Retail Point of Sale Models —
RS-232, RS-232 OPOS, USB,
IBM 46XX (with accessory cable)
Configuring the Interface
Scan the programming barcode which selects the appro-
priate interface type matching the system the reader will
be connected to.
Next, proceed to the corresponding chapter in the Gry-
phon™ I GD4132/GM4102 PRG to customize any settings
and features associated with that interface.
Unlike some other programming features and
options, interface selections require that you
scan only one programming barcode label. DO
NOT scan an ENTER/EXIT barcode prior to
scanning an interface selection barcode.
Some interfaces require the scanner to start in
the disabled state when powered up. If addi-
tional scanner configuration is desired while in
this state, pull the trigger and hold for 5 sec-
onds. The scanner will change to a state that
allows programming with barcodes.
