GRYPHON™ MX30
1
USING GRYPHON™ M SERIES READERS
The Gryphon™ M series reader, paired with an OM-Gryphon™ cradle, builds a
Cordless Reading System for the collection, decoding and transmission of
barcoded data.
Gryphon™ M readers automatically scan barcodes
at a distance
. Simply aim
and pull the trigger. Code scanning is performed along the center of the light bar
emitted from the reading window. This bar must cover the entire code.
READING ANGLE
Successful scanning is obtained by tilting the reader with respect to the barcode
to avoid direct reflections, which impair the reading performance, see the figure
below.
Successful reading is obtained by an audible tone plus a good-read green spot.
OK
Not
Advised
To start using your Gryphon™ M
reading system you must:
1. Connect an OM-Gryphon™ cradle to the Host. For installation and
connection information see the OM-Gryphon™ Quick Reference Manual.
2.
Charge the Gryphon™ M battery using an OM-Gryphon™ / C-Gryphon™
charger as described in this Quick Reference manual. A full charge takes
3.5 hours with NiMh battery models.
3.
Configure the reader as described in this Quick Reference manual.
4.
Configure the OM-Gryphon™ cradle. See OM-Gryphon™ Configuration in
the “OM-Gryphon™ Quick Reference”.
Good read spot
Good read LED
