GRYPHON™ MX30
3
When the above procedure is no longer effective, the batteries must be
changed. To change the batteries of your reader, unscrew the battery cover
screw, replace the old batteries with new ones, then insert the cover in the
handle and screw it back into place. (See the following figures).
WARNING
Do not incinerate, disassemble, short terminals or
expose to high temperature. Risk of fire, explosion. Use
specified charger only. Risk of explosion if the battery
is replaced by an incorrect type. Dispose of the
batteries as required by the relevant laws in force.
GRYPHON™ M CONFIGURATION
When the OM-Gryphon™ cradle is connected and powered, configure the
Gryphon™ M by reading the following codes in the given sequence and follow the
instructions.
Note:
for the numeric code selection of step 3, use the table at the end of this
Quick Reference.
Restore Gryphon™ M default
1.
Ì$+$*oÎ
Enter configuration
2.
Ì$+;Î
Set Radio Address
3.
ÌRF8Î
+
four digits for the Gryphon™ M Address
(from 0000 to 1999).
All readers used in the same area must have different addresses.
+