INITIAL SETUP
3
2 INITIAL SETUP
2.1 INTERFACE SELECTION
Follow the procedure to configure the interface required by your application
•
USB
Interface
•
RS232
Interface
•
Wedge
Interface
•
Pen Emulation Interface
•
IBM 46xx Interface
2.1.1
USB Interface Configuration
The USB interface is compatible with:
-
Windows 98 (and later)
-
Mac OS 8.0 (and later)
-
IBM POS for Windows
-
4690 Operating System
The USB interface is compatible with:
Windows 98 (and later)
IBM POS for Windows
Mac OS 8.0 (and later)
4690 Operating System
START-UP
As with all USB devices, upon connection, the Host performs several checks by
communicating with the USB device. During this phase the LED on the device blinks
and normal operations are suspended. Two basic conditions must be met before the
USB device is ready to read codes, the correct USB driver must be loaded and
sufficient power must be supplied to the reader.
For all systems, the correct USB driver for the default USB-KBD interface is included
in the Host Operating System and will either be loaded automatically or will be
suggested by the O.S. and should therefore be selected from the dialog box (the first
time only).
If the Host supplies sufficient power to the reader, the start-up phase ends correctly,
the LED stops blinking and the reader emits the beep OK signal.
Summary of Contents for Hand-Held Devices II
Page 8: ...viii...
Page 36: ...28...
Page 108: ...Exit and Save Configuration ADVANCED FORMATTING 100...
