USER MANUAL
13
CHAPTER 6
PARAMETER CONFIGURATION
WEB SERVER CONFIGURATION
LGS-N50 parameters are configured on the web server as follows:
•
Open the web browser (recommended: Chrome, Firefox, Edge and other stan-
dards-compliant browsers). Enter the LiDAR IP address.
•
The model and version are the product model and firmware version, shown on the
upper end of the interface.
•
The Temperature and Voltage on the right side of the interface are LiDAR's real-
time parameters, which indicate the temperature and voltage information of spe-
cific modules inside. When the parameter font turns red, the LiDAR may not be
working properly.
•
The current LiDAR settings are automatically loaded when the page is refreshed.
•
Select the required speed value by Motor RPM: 600/900/1200/1500, correspond-
ing to the 10/15/20/25Hz LiDAR scanning frequency, confirm by clicking Set Con-
figs.
•
Turn on/off DHCP: if ON, then LiDAR dynamically obtains the IP address from the
DHCP server. If OFF, then LiDAR needs to set the static IP address.
•
Change LiDAR IP: HostIP and LiDAR IP should be in the same network segment;
click Set Network key to confirm, restart the LiDAR and the modification is com-
pleted.
Figure 13 - Web Page parameter configuration
Preliminary 13-Jan-2021
Summary of Contents for LGS-N50
