1.15 AUTOSTART
The AutoStart program provides three functions:
-
Allows you to create a list of applications (with optional command line
arguments) to run automatically prior to loading CAB files.
-
Automatically reinstalls specified CAB files when the Lynx 10 is cold booted.
-
Allows you to create a list of applications (with optional command line
arguments) to run automatically after loading CAB files.
AutoStart launches each time the Lynx is rebooted executing each line with the
specified command line arguments. It will take into account any AutoStart options at
the beginning of the line.
Upon a Cold Boot, AutoStart installs all the CAB files located in the \FlashDisk\CAB
folder. If the CAB folder does not exist, no CAB files will be installed.
AutoStart will then run the
Autostart.ini
from the \FlashDisk directory,
executing each line with the specified command line arguments. It will take into
account any AutoStart options at the beginning of the line.
1.15.1 Installing CAB files
Copy any CAB files you want to install into the \FlashDisk\CAB folder. These CAB
files will then be automatically in-stalled in alphabetical order the next time you start
the device.
Summary of Contents for Lynx 00N0LD-1N0-MEN0
