ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
29
Digital Watermark (Digimarc) Double Read Timeout
Specifies the minimum allowable time which must pass before reading the same Digital
Watermark (Digimarc) label again (e.g. two identical items in succession).
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan your selection from the barcodes below. You’ll need to cover any unused bar
‐
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
barcode.
NOTE
00521E(CR)
Digimarc Double Read Timeout = 0.3 Seconds
005228(CR)
Digimarc Double Read Timeout = 0.4 Seconds
DEFAULT
005232(CR)
Digimarc Double Read Timeout = 0.5 Seconds
005246(CR)
Digimarc Double Read Timeout = 0.7 Seconds
005264(CR)
Digimarc Double Read Timeout = 1 Second
If the incidence of multiple reads is not acceptable, increase the Double Read
Timeout setting to a higher value.
Summary of Contents for Magellan 1500i
