ENTER/EXIT PROGRAMMING MODE
122
MAGELLAN™ 1500I
Global Mid-Label ID
This feature specifies a global mid
‐
label ID that is added between two barcodes for trans
‐
mission.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan the barcode “Set Global Mid
Label ID” below. You’ll need to cover any unused
barcodes on this and the facing page to ensure the scanner reads only the barcode
you intend to scan.
3. Scan the appropriate digits from the Alpha
‐
Numeric Keypad in
that repre
‐
sent the desired mid
‐
label ID characters; entered as two hex pairs. A table containing
the ASCII Character Set and their corresponding Hex Values is available in the inside
back cover of this manual. ASCII parameters must be input by scanning a pair of hexa
‐
decimal digits for each character. Thus, to set a two
‐
character value of AB, barcodes
containing the digits ‘4’, ‘1’, ‘4’, and ‘2’ must be scanned. The selectable range for this
option is any hex value from 00 to FF.
Complete the programming sequence by scanning the Enter/Exit Programming Mode bar
‐
code.
04C7(CR)
Set Global Mid-Label ID
DEFAULT
Default Label ID for this symbology is:
00 = No Global Mid-label ID
Summary of Contents for Magellan 1500i
