ENTER/EXIT PROGRAMMING MODE
26
MAGELLAN™ 1500I
2D Double Read Timeout
The 2D Double Read Timeout feature specifies the minimum allowable time which must
pass before reading the same 2D label again (e.g. two identical items in succession).
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page at the top of
the page.
2. Scan your selection from the barcodes below. You’ll nee
3. d to cover any unused barcodes on this and the facing page to ensure that the scanner
reads only the barcode you intend to scan.
4. Complete the programming sequence by scanning the Enter/Exit Programming Mode
barcode.
NOTE
03DF1E(CR)
2D Double Read Timeout = 300ms
03DF28(CR)
2D Double Read Timeout = 400ms
03DF3C(CR)
2D Double Read Timeout = 600ms
03DF46(CR)
2D Double Read Timeout = 700ms
03DF50(CR)
2D Double Read Timeout = 800ms
If the incidence of multiple reads is not acceptable, increase the Timeout set-
ting to a higher value.
DEFAULT
Summary of Contents for Magellan 1500i
