2
Magellan™ 3200VSI
Connecting the Scanner
The scanner kit you ordered to match your interface should provide a compati-
ble cable for your installation. Alternatively, if your scanner receives Power Off
the Terminal (POT) it might be possible to connect using a cable from a previ-
ously existing installation (except for USB). If you wish to connect using an
existing cable, but cannot use POT, a short adapter cable is available. Check
with your technical support representative about compatibility before connect-
ing. Use the appropriate instructions below when you’re ready to connect the
scanner to the terminal, PC or other host device.
Upon completing the connection via the appropriate interface instructions
below, proceed to the
scan the bar code to select the correct interface type.
RS-232 Serial Connection —
Turn off power to the terminal/PC and connect the
scanner to the terminal/PC serial port via the RS-232 cable as shown in
a. If the terminal will not support POT (Power Off the Terminal) to supply scan-
ner power, use the approved power supply (AC Adapter) as shown in
b.
Plug the AC Adapter barrel connector into the socket on the RS-232 cable con-
nector and the AC Adapter plug into a standard power outlet.
Figure 1. Connecting the Scanner
US
B
IB
M
or...
or...
Terminal (PC)
RS
-2
3
2
a
Power Off
the Terminal
(POT)
U
S
B
R
S
-2
32
To Terminal (PC)
To Terminal (PC)
Other Non-POT Cables
Powered by AC Adapter
via short adapter cable
b
c
Keyboard Wedge, RS-232
and USB Cables
Powered by AC Adapter
Keyboard
Wedge
USB Connection —
Connect the scanner to a USB port on the terminal/PC using
the correct USB cable for the interface type you ordered. Reference
NOTE
USB installations may require a power connection via an
approved A/C Adapter as shown in
b or
c.
For example, this would be the case if the scanner is con-
nected along with a number of other devices to a non-pow-
ered USB hub.
IBM Connection —
Connect the scanner to the IBM port on the terminal/PC
using the correct IBM cable. Reference
.
Keyboard Wedge Connection —
Before connection, turn off power to the termi-
nal/PC. The Keyboard Wedge cable has a ‘Y’ connection from the scanner. Con-
Summary of Contents for MAGELLAN 3200VSI
