Product Reference Guide
173
Appendix F
Host Commands
Accepting RS-232 Commands
The scanner responds to the following RS-232 commands:
COMMAND
ASCII
HEX
COMMENT
Enable Scan-
ner
E
0x45
Disable
Scanner
D
0x44
Reset Scanner
R
0x52
Not On File
Indication
F
0x46
Long series of beeps
Beep Good
Read Tone
B
0x42
Beeps if Good Read Beep is enabled
Force Good
Read Tone
!
0x01
Beeps regardless of beep setting
Identification
request
i
0x69
Returns long response
a
a. Call Tech Support for information.
Health
request
h
0x68
Returns long response
Status
request
s
0x73
Returns long response
If one of the above commands is received, the scanner will perform the steps
indicated for the command. Host commands for other interfaces are also avail-
able. Contact Tech Support for more details.
Also see the section
"Image Capture to the Host by Host Command"
for details concerning that feature.
Summary of Contents for MAGELLAN 3200VSI
