Error Codes
10
MAGELLAN™ 3510HSI
ERROR CODES
If an error is detected, the scanner will sound a long low tone (for three
seconds) and flash its LED, indicating a failure. When this occurs, press
the Scanner button to hear the error code. If it is configured to do so,
the scanner will sound a series of beeps corresponding to the error code
and/or flash its LED simultaneous to the beeps. The table below
describes what these codes mean and what action should be taken for
each.
PROGRAMMING
Upon completing the physical connection between the scanner and its
host, proceed directly to the Programming Bar Codes table below to
locate the interface type the scanner is connected to (for example: RS-
232, USB, etc.).
Use the Bar Code Mask at the back of this manual to isolate the bar code
you want to scan. Scan a START/END bar code once to enter
Programming Mode. After scanning the programming label, scan the
START/END barcode a second time to accept your changes, exit
Programming Mode and return the scanner to normal operation.
Select other options and customize your scanner with programming
barcodes available in the PRG, or use the Datalogic Scanalyzer utility
available on the Datalogic website.
NUMBER OF LED
FLASHES/BEEPS
ERROR
CORRECTIVE ACTION
1
Configuration
Contact Helpdesk for assis-
tance
2
Host Interface
6
Main PCB
10
Button Error
11
USB Device
13
CPLD ID
NOTE: In the following sections, text shown with a green
star indicates a factory default value.
This is an example of a default value.
