Product Reference Guide
6-109
Set Single Cable RS-232 STX Character
This feature selects the STX character.
To specify the STX Character:
1. Scan the SWITCH bar code.
2. Scan the bar code,
SET SINGLE CABLE RS-232 STX CHARAC-
below. You’ll need to cover any unused bar codes on this and
the facing page to ensure the scanner reads only the bar code you
intend to scan.
3. Scan the appropriate characters/digits from the keypad in
that represent the decimal designation for the desired
character. A table containing the
corresponding decimal values is available in the inside back cover
of this manual. ASCII parameters must be input by scanning dec-
imal digits for each character. Pad all numbers with leading zeroes
to yield a three-digit entry (001-127). Thus, to set a single charac-
ter value of A, bar codes containing the digits ‘0’, ‘6’ and ‘5’ must
be scanned. The selectable range for this option is any decimal
value from 001 to 127.
4. The scanner will automatically exit Programming Mode when the
appropriate amount of digits have been scanned.
SET SINGLE CABLE RS-232 STX CHARACTER
Summary of Contents for MAGELLAN 8500 Omega
