Product Reference Guide
6-85
RS-232 Intercharacter Delay
Specifies delay between the end of one character and the beginning of the
next in 10-millisecond increments.
To set the RS-232 Intercharacter Delay:
1. Scan the SWITCH barcode.
2. Scan the barcode below,
. You’ll need to cover any unused barcodes on this and the
facing page to ensure that the scanner reads only the barcode you
intend to scan.
3. Scan the appropriate digits from the keypad in
that
represent the desired delay. The selectable range is 0-100, which is
the delay in 10-millisecond increments. Pad all single and double
digit numbers with leading zeroes to yield a three-digit entry
(000-100).
Examples:
001 = 10ms
005 = 50ms
040 = 400ms
100 = 1,000ms (1 second)
4. The scanner will automatically exit Programming Mode when the
appropriate amount of digits have been scanned.
SET RS-232 INTERCHARACTER DELAY
Summary of Contents for MAGELLAN 8500?
