Enter/Exit Programming Mode
160
Magellan™ 9800i Scanner
EAS Features — Checkpoint
The features in this section apply only to Checkpoint
®
to set options for that system.
ERI Active State
Specifies the active state polarity of ERI; the inactive state is its opposite polarity. ERI
output goes active during the good read of a bar code, allowing the EAS device to deactivate
a tag on the product.
To set the ERI Active State:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any unused bar
codes on this and the facing page to ensure that the scanner reads only the bar code you
intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode
bar code.
DEFAULT
00F900(CR)
ERI Active State = Active Low
00F901(CR)
ERI Active State = Active High
Summary of Contents for Magellan 9800i
