Enter/Exit Programming Mode
Product Reference Guide
169
Maximum Host-Transmitted Message Length
Specifies the maximum number of data characters allowed in messages transmitted to the host.
To set the Maximum Host-Transmitted Message Length:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan the bar code,
Set Maximum Host-Transmitted Message Length
below. You’ll need
to cover any unused bar codes on this and the facing page to ensure that the scanner reads
only the bar code you intend to scan.
3. Scan the appropriate digits from the
that represent the desired
maximum host-transmitted message length. The selectable range is 0-249 data characters.
(Labels that are longer than this length are not read.) Pad all single and double digit num-
bers with leading zeroes to yield a three-digit entry (000-249).
NOTE
If this configuration item is set to 0 (000), there is no general length limit
imposed on data being transmitted to the host.
4. The scanner will automatically exit Programming Mode when the appropriate amount of
digits have been scanned.
06B1(CR)
Set Maximum Host-Transmitted Message Length
DEFAULT
Default setting for this feature is:
000 - No general limit imposed
Summary of Contents for Magellan 9800i
