Enter/Exit Programming Mode
184
Magellan™ 9800i Scanner
RS-232 Intercharacter Delay
Specifies delay between the end of one character and the beginning of the next in 10-
millisecond increments.
To set the RS-232 Intercharacter Delay:
1. Scan the Enter/Exit Programming Mode bar code.
Set RS-232 Intercharacter Delay
. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner reads only the bar
code you intend to scan.
3. Scan the appropriate digits from the
that represent the desired
delay. The selectable range is 0-100, which is the delay in 10-millisecond increments. Pad
all single and double digit numbers with leading zeroes to yield a three-digit entry (000-
100).
Examples:
001 = 10ms
005 = 50ms
040 = 400ms
100 = 1,000ms (1 second)
4. The scanner will automatically exit Programming Mode when the appropriate amount of
digits have been scanned.
009C(CR)
Set RS-232 Intercharacter Delay
DEFAULT
Default setting for this feature is:
00 - No Intercharacter Delay
Summary of Contents for Magellan 9800i
