Enter/Exit Programming Mode
Product Reference Guide
209
Set Single Cable RS-232 ETX Character
Allows selection of the ETX character.
To specify the ETX Character:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan the bar code,
Set Single Cable RS-232 ETX Character
any unused bar codes on this and the facing page to ensure the scanner reads only the bar
code you intend to scan.
3. Scan the appropriate characters/digits from the
that represent the
decimal designation for the desired character. A table containing the ASCII Character Set
and their corresponding decimal values is available in the inside back cover of this manual.
ASCII parameters must be input by scanning decimal digits for each character. Pad all
numbers with leading zeroes to yield a three-digit entry (001-127). Thus, to set a single
character value of A, bar codes containing the digits ‘0’, ‘6’ and ‘5’ must be scanned. The
selectable range for this option is any decimal value from 001 to 127.
4. The scanner will automatically exit Programming Mode when the appropriate amount of
digits have been scanned.
047A(CR)
Set Single Cable RS-232 ETX Character
DEFAULT
Default setting for this feature is:
00D - CR
Summary of Contents for Magellan 9800i
