Enter/Exit Programming Mode
Product Reference Guide
115
Label Gone Timeout
Specifies the amount of time in cycles (one cycle = 25ms) that data segments are stored by the
software before being discarded if a label has not been successfully decoded during the current
“label in volume session,” which is defined as the time between when the label gone time is first
started until the label gone timer expires.
NOTE
This only applies to UPC/EAN labels when segment assembly is enabled.
To set the Label Gone Timeout:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You’ll need to cover any unused bar codes
on this and the facing page to ensure that the scanner reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode bar code.
DEFAULT
004C10(CR)
Label Gone Timeout = 0.4 Seconds
004C18(CR)
Label Gone Timeout = 0.6 Seconds
004C20(CR)
Label Gone Timeout = 0.8 Seconds
Summary of Contents for Magellan 9800i
