Enter/Exit Programming Mode
Product Reference Guide
197
RS-232 ACK NAK Retry Count
This feature sets the number of times for the scanner to retry a label transmission under a retry
condition.
To set the RS-232 ACK NAK Retry Count:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan the bar code,
Set RS-232 ACK NAK Retry Count
below. You’ll need to cover any
unused bar codes on this and the facing page to ensure that the scanner reads only the bar
code you intend to scan.
3. Scan the appropriate digits from the
that represent the desired
number. The selectable range is 000-255 resets. Pad all single and double digit numbers
with leading zeroes to yield a three-digit entry (000-255).
NOTE
A setting of 255 specifies “retry forever.”
4. The scanner will automatically exit Programming Mode when the appropriate amount of
digits have been scanned.
0608(CR)
Set RS-232 ACK NAK Retry Count
DEFAULT
Default setting for this feature is:
003 - Three retrys
Summary of Contents for Magellan 9800i
