Product Reference Guide
75
Chapter 6
Calibration Procedures
NOTE
This section applies to scanner/scale models with single or dual interval.
Make sure to follow the proper associated procedure for each of these
options. Procedures specific to
single
interval units is highlighted in a
salmon color
. Procedures specific to
dual
interval units is highlighted
ina
teal color
.
These procedures are not applicable for adaptive scale models. Consult
your adaptive scale documentation or the adaptive scale manufacturer for
more information.
A number of situations require the scale to be calibrated. They are:
•
at initial installation of the scanner/scale
•
if the scale cannot be rezeroed
•
when changing the weight measure from pounds to kilograms or vice-versa
•
if diagnostics indicate a calibration error
•
when removing/replacing any scale assembly or the Main Board
•
when required by local regulations
Follow the procedures on the following pages to ensure that the scanner/scale will meet
Weights and Measurement requirements.
LEGAL NOTE
CAUTION
DO NOT apply a calibration seal to include the EAS antenna (if one is present).
Reference
.
If the antenna must be removed for other reasons, this
would unnecessarily cause the scale to require recalibration.
Certification of the scanner/scale’s weighing apparatus is subject to Fed-
eral, State and Local Weights and Measures statutes and is restricted to
authorized government agencies and/or duly registered agents thereof.
Anytime a scale is calibrated, it should be properly sealed with a lead and
wire or paper seal before being placed into service.
It is your responsibility to check with the appropriate authorities in your
area to ensure compliance with pertinent regulations before removing
any official seals or placing a newly calibrated scanner/scale into service.
Summary of Contents for Magellan 9800i
